Dell T605, DR715 owner manual Troubleshooting an Optical Drive, 179

28Repeat step 20 through step 27 until all expansion cards are reinstalled or one of the expansion cards causes the tests to fail.

If the problem is not resolved, see "Getting Help" on page 205.

Troubleshooting an Optical Drive

Problem

•System cannot read data from a CD or DVD in an optical drive.

•Optical drive indicator does not blink during boot.

Action

CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. Before performing any procedure, see your Product Information Guide for complete information about safety precautions, working inside the system and protecting against electrostatic discharge.

1Try using a different CD or DVD that you know works properly.

2Enter the System Setup program and ensure that the optical drive controller is enabled. See "Entering the System Setup Program" on page 43.

3Run the appropriate online diagnostic test. See "Using Dell PowerEdge Diagnostics" on page 193.

4Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.

5Open the system. See "Opening the System" on page 68.

6Ensure that the interface cable is securely connected to the optical drive and to the controller.

7Ensure that the power cable is properly connected to the drive.

8Close the system. See "Closing the System" on page 70.

9Reconnect the system to the electrical outlet, and turn on the system and attached peripherals.

If the problem is not resolved, see "Getting Help" on page 205.

Troubleshooting Your System

179