Dell DR715, T605 owner manual Installing the Processor Shroud, Shroud touch point, Gripping points

5	shroud touch point	6	rear shroud tab slots (2)
7	tab slots (2)	8	front shroud tab slot
9	shroud alignment guide	10	front shroud lip
11	release latch	12	cable guides (4)
13	shroud latch	14	front shroud alignment tab
15	gripping points

5Disconnect the SATA cable(s) from the system board and remove the cable(s) from the cable guides. Lay the SATA cables away from the processor shroud.

6If present, disconnect any SAS cables from the SAS card to the hard drives and remove the cables from the cable guides. Lay the SAS cables away from the processor shroud.

7Disconnect all power cables to any drives in the system.

8Pull the release latch in the direction of the arrow. Holding the latch and the shroud touch point, lift the shroud up and out of the chassis. See Figure 3-6.

Installing the Processor Shroud

1Carefully lower the shroud into the chassis, inserting the front shroud lip under the shroud alignment guide, and inserting the shroud alignment tabs into the tab slots in the chassis. Make sure that no cables are pinned under the bottom edges of the shroud, and press down on the shroud until the shroud latch locks into place. See Figure 3-6.

2Route the SATA cable(s) under the cable guides, and connect the SATA cables to the SATA connectors on the system board. See Figure 3-11 for SATA hard drive cable-routing guidelines and Figure 3-22 for SATA optical drive cable-routing guidelines.

3Route the ribbon cables under the ribbon cable slot, and connect the cables to the connectors on the system board. See Figure 3-17 for ribbon cable routing guidelines.

4If applicable, route the SAS-card cables through the shroud cable guides, and connect the cables to the hard drives. See Figure 3-12 for cable routing guidelines.

74

Installing System Components