Dell DR715 E1A15 SAS Cable D, E1A18 PDB Ctrl, E1A19 12V Cable, Fault, E1B01 USB#, Overcurrent

Table 1-5. LCD Status Messages (continued)

Code	Text	Causes	Corrective Actions
E1A15	SAS Cable D	SAS cable D is missing or	Reseat the cable. If the
		bad.	problem persists, replace
			cable.
			If the problem persists,
			see "Getting Help" on
			page 205.
E1A18	PDB Ctrl	Control cable for the power	Reseat the cable. If the
	Cable	distribution board (PDB) is	problem persists, replace
		missing or bad.	cable.
			If the problem persists,
			see "Getting Help" on
			page 205.
E1A19	12V Cable	Power cable for the PDB or	Reseat the cable. If the
	Fault	cabled power supply is	problem persists, replace
		missing or bad. They system	cable.
		will not turn on.	If the problem persists,

see "Getting Help" on page 205.

E1B01 USB#	Device plugged in the
Overcurrent	specified USB port caused
	an overcurrent condition.

Reseat the device cable. If the problem persists, replace or remove the device.

E2010 No Memory	No memory is installed in
	the system.

Install memory (see "Installing Memory Modules" on page 130).

E2011	Mem Config	Memory detected, but is not	See "Troubleshooting
	Err	configurable. Error detected	System Memory" on
		during memory	page 174.
		configuration.
E2012	Unusable	Memory is configured, but	See "Troubleshooting
	Memory	not usable. Memory	System Memory" on
		subsystem failure.	page 174.

28

About Your System