Dell T605, DR715 PCIe Fatal Error, Caused a system, Reset Slot, Embedded, Bus#XX/Dev#XX/Fu

Table 1-6. System Messages (continued)

Message	Causes	Corrective Actions
PCIe Fatal Error	PCI Express fatal errors	Reseat the PCIe card in the
caused a system	occurred during the previous	specified slot number (see
reset: Slot X	boot.	"Installing an Expansion
Embedded		Card" on page 110). If the
		problem persists, see
Bus#XX/Dev#XX/Fu
		"Getting Help" on page 205.
ncX
Please check the
system event log
for details
Plug & Play	Error encountered in	Install the NVRAM_CLR
Configuration	initializing PCIe device;	jumper and restart the
Error	faulty system board.	system. See Figure 6-1 for
		jumper location. If the
		problem persists, see
		"Troubleshooting Expansion
		Cards" on page 187.

Read fault

Requested sector not found

Remote configuration update attempt failed

The operating system cannot read from the hard drive or USB device, the system could not find a particular sector on the disk, or the requested sector is defective.

System unable to process Remote Configuration request.

Replace the USB medium or device. Ensure that the USB or hard drive cables are properly connected. See "Troubleshooting a USB Device" on page 165, or "Troubleshooting a Hard Drive" on page 181 for the appropriate drive(s) installed in your system.

Retry Remote Configuration.

About Your System

37