Dell DR715, T605 ROM bad checksum, Sector not found, Seek error, Seek operation, Shutdown failure

Table 1-6. System Messages (continued)

Message	Causes	Corrective Actions
ROM bad checksum	Expansion card improperly	Reseat the expansion card(s).
= address	installed or faulty.	Ensure that all appropriate
		cables are securely connected
		to the expansion card(s). If
		the problem persists, see
		"Troubleshooting Expansion
		Cards" on page 187.

SATA PORT x drive SATA port x was turned on in

not found setup, but a drive was not found.

See "Troubleshooting a Hard Drive" on page 181 for the appropriate drive(s) installed in your system.

Sector not found	Faulty hard drive, USB	See "Troubleshooting a USB
Seek error	device, or USB medium.	Device" on page 165 or
		"Troubleshooting a Hard
Seek operation
		Drive" on page 181 for the
failed
		appropriate drive(s) installed
		in your system.
Shutdown failure	Shutdown test failure.	See "Troubleshooting System
		Memory" on page 174.

Spare bank	DIMM sparing has been
enabled	enabled.
The amount of	Memory has been added or
system memory has	removed or a memory
changed	module may be faulty.

Information only.

If memory has been added or removed, this message is informative and can be ignored. If memory has not been added or removed, check the SEL to determine if single-bit or multi-bit errors were detected and replace the faulty memory module (see "Troubleshooting System Memory" on page 174).

38

About Your System