Enterasys Networks 2H253 manual Vlan Classification Configuration Screen, Admit Tagged Frames only

VLAN Classification Configuration Screen

5.Use the arrow keys to highlight the port’s Acceptable Frame Types field.

6.Press the SPACE bar to toggle the field to the correct setting: ADMIT ALL FRAMES or

ADMIT TAGGED FRAMES ONLY.

7.Use the arrow keys to highlight the port’s Ingress Filtering field.

8.Press the SPACE bar to toggle the field to the correct setting: ENABLED or DISABLED. This will either enable or disable the filtering set in the Acceptable Frame Type field in step 5.

9.Use the arrow keys to highlight the port’s GVRP Status field.

10.Press the SPACE bar to toggle the field to the correct setting: ENABLED or DISABLED.

11.To configure more than one port, repeat step 1 through step 10. Then go to step 12 to save your settings.

12.Use the arrow keys to highlight the SAVE command at the bottom of the screen.

13.Press ENTER. The message “SAVED OK” displays and all settings are saved.

7.8VLAN CLASSIFICATION CONFIGURATION SCREEN

When to Use

To perform the following:

•Display the VLAN ID (VID), Protocol Classification, and Description of each classification of the current entries.

•Assign VLANs according to Classification rules.

•Add/delete a VID and associated classification entry.

•Access the Protocol Port Configuration screen.

When a frame is received that already contains an 802.1Q frame tag, frame classification is not implemented. Instead, the frame is processed by the SmartSwitch device according to the information contained in the 802.1Q frame tag. When the frame is transmitted, it is sent to the ports associated with the VLAN as established using the Protocol Port Configuration screen described in Section 7.9.

802.1Q VLAN Configuration Menu Screens 7-21