HSIM/VHSIM Configuration Screen

5.4HSIM/VHSIM CONFIGURATION SCREEN

When to Use

To configure an optional HSIM or VHSIM.

NOTE: The HSIM/VHSIM Configuration menu item can only be selected when a non-Ethernet HSIM or VHSIM is installed in the switch device. The applicable setup screen for that interface displays. This only applies to HSIMs and VHSIMs that can support WAN, FDDI or ATM. Refer to the appropriate HSIM or VHSIM user’s guide to set its operating parameters.

How to Access

Use the arrow keys to highlight the HSIM/VHSIM CONFIGURATION menu item on the Port Configuration Menu screen and press ENTER. The applicable HSIM or VHSIM setup screen displays. Refer to the appropriate HSIM or VHSIM user’s guide for instructions on using the Local Management screens for that interface.

5.5REDIRECT CONFIGURATION MENU SCREEN

Screen Navigation Path

Password > Device Menu > Device Configuration Menu > Port Configuration Menu > Redirect

Configuration Menu

When to Use

To access the Port Redirect Configuration and VLAN Redirect Configuration screens. Any combination, up to 128, of port and/or VLAN redirect instances can be configured from these screens. This feature is useful in troubleshooting. It enables you to monitor traffic at a destination port using analyzers, RMON probes, and IDS sensors.

How to Access

Use the arrow keys to highlight the REDIRECT CONFIGURATION MENU item on the Port Configuration Menu screen and press ENTER. The Redirect Configuration Menu screen, Figure 5-5, displays.

Port Configuration Menu Screens 5-13

Page 141
Image 141
Enterasys Networks 2H253, 2E253, 2H252, 2H258 manual HSIM/VHSIM Configuration Screen, Redirect Configuration Menu Screen