Enterasys Networks 2H258, 2E253, 2H253, 2H252 manual Configuring a Port, Add

Rate Limiting Configuration Screen

Table 8-10 Rate Limiting Configuration Screen Field Descriptions (Continued)

Use this field… To…

Max Rate: kbps Enter the maximum transmission rate for this entry. The maximum

(Modifiable)transmission rate includes all frames associated with the priorities selected in the Priority List field. The default is the high setting of 100 Kbps maximum interface speed. The high range setting is 100 Kpbs to 1 Gbps. The low range setting is 50 to 40000 Kpbs.

For details on rate limiting, refer to Section 8.8.1.

		NOTE: For further details on configuring the rate limiting range
		on a port, refer to the rate_limit_mode command in
		Section 11.2.
ADD	Add the current port, priority, and maximum rate selections to the
(Command)	screen. For details about how to configure and add an entry, refer to
	Section 8.8.1.
DEL ALL/DEL	Delete all or one or more marked entries. The DEL ALL command is
MARKED	the default and it is used to simultaneously delete all the lines of
(Toggle)	configured information. The DEL MARKED command appears in
	place of the DEL ALL command when one or more lines are marked
	for deletion. For details on using the two commands, refer to
	Section 8.8.2.

8.8.1Configuring a Port

The following describes how to configure a port using the Rate Limiting Configuration screen:

1.To enter a Port Type, proceed to step 2. To enter a port number, proceed as follows:

a.Use the arrow keys to highlight the field (1) below the Port Number field.

b.Type in the port number and press ENTER.

c.Proceed to step 3.

802.1p Configuration Menu Screens 8-41