Enterasys Networks 2E253, 2H253, 2H252, 2H258 manual Local Management Screen Elements, None Defined

30691_01

Local Management Screen Elements

You can also access Local Management using a Telnet connection through one of the network ports of the SmartSwitch device.

NOTE: For details on the setup parameters for the console, how to connect a console to the SmartSwitch, or how to make a telnet connection, refer to Chapter 2.

1.4LOCAL MANAGEMENT SCREEN ELEMENTS

There are six types of screens used in Local Management: password, menu, statistics, configuration, status, and warning screens. Each type of screen can consist of one to five basic elements, or fields. Figure 1-1shows an example of the fields in a screen. A description of each field follows the figure.

Figure 1-1 Example of a Local Management Screen

Event Message Field			Display Field		See
		Display Fields	Input Fields
					Note
Event Message Line
		xxxxx-xx LOCAL MANAGEMENT
		General Configuration
Device Type: xxxxx-xx			Firmware Revision:	XX.XX.XX
			BOOTPROM Revision: XX.XX.XX
MAC Address:		00-00-ID-00-00-00	Device Date:	10/11/97
IP Address:		0.0.0.0	Device Time:	14:23:00
Subnet Mask:		255.255.0.0	Screen Refresh Time:	30 sec.
Default Gateway:		NONE DEFINED	Screen Lockout Time:	15 min.
TFTP Gateway IP Addr:		0.0.0.0	Device Uptime XX D XX H XX M
Operational Mode:	[802.1Q SWITCHING]
Clear NVRAM	[NO]	IP Fragmentation [ENABLED]
SAVE		EXIT		RETURN
Selection Field		Command Fields

Note: This shows the location of the cut away that is used in most of the screen graphics in this document. The top portion of the screen is cut away to eliminate repeating the same information in each graphic.The screen title is contained in its figure title.

1-4Introduction