Enterasys Networks 2H252, 2E253, 2H253, 2H258 manual Ratelimitmode, Examples Cont’d

Built-in Commands

radius (Continued)

Examples:

(Cont’d)

NOTE: The following shows examples of when 3, 7, and 32 characters are entered as the secret code (16 to 32 characters are recommended).

->radius sec_secret

Enter Secret (max 32): ***

Confirm Secret: ***

#ERROR : secret minimum length is 6 -> radius sec_secret

Enter Secret (max 32): *******

Confirm Secret: *******

Warning: rfc2865 recommends min length of 16 ok

->radius sec_secret

Enter Secret (max 32): ********************************

Confirm Secret: ********************************

ok

rate_limit_mode

Description: Displays the status of rate limiting or configures the exit-rate limit range to either the default high_range (100 Kbps to 1 Gbps) or the low range (50 Kbps to 400 Mbps). This mode is stored in non-volatile memory and is retained by normal resetting. Changing from one mode to the other mode may result in current settings being removed if their range is no longer valid. Changing rate limit mode will require a reset.

Syntax: rate_limit_mode [ status ] [ high_range (default) ] [ low_range ]

Options: status — Displays rate limiting status. high_range — Sets the default rate limit high range. low_range — Sets the default rate limit low range.

11-26Network Tools Screens