Protocol Port Configuration Screen

Switch 1

The following settings are done using the Priority Classification Configuration screen to assign the classification to the priority. Then the Protocol Port Configuration screen is used to assign the ports to the appropriate priority and classification.

NOTE: In the two settings below, the subnet mask is set to 255.255.255.255. This means that frames with a source or destination address of 123.123.30.6 or 123.123.30.7 will be mapped as a priority 7 or 0, respectively.

1.To set the SAP Server (IP 123.123.30.6) to the highest priority (7), the following settings will be made using the Priority Classification Configuration screen:

PID: 7

Classification: Bil IP Address

IP Address: 123.123.30.6

Data Mask: 255.255.255.255

2.Assign all ports on the SmartSwitch device to use this classification setting.

3.To set the Mail Server (IP 123.123.30.7) to the lowest priority (0), the following settings will be made using the Priority Classification Configuration screen:

PID: 0

Classification: Bil IP Address

IP Address: 123.123.30.7

Data Mask: 255.255.255.255

4.Assign all ports on the SmartSwitch device to use this classification setting.

Switch 2

The Switch 1 setup instructions are repeated to set up Switch 2.

NOTE: For optimal operation of the prioritizing function, the connection between S1 and S2 is set for 802.1Q tagging.

8-36802.1p Configuration Menu Screens

Page 262
Image 262
Enterasys Networks 2H252, 2E253, 2H253, 2H258 manual Switch