Enterasys Networks 2E253, 2H253, 2H252 Setting Switch Port Priority Port-by-Port, Policy Override

Port Priority Configuration Screen

Table 8-2 Port Priority Configuration Screen Field Descriptions

Use this field…	To…
Port #	See the port number. Up to 10 rows of port numbers can be displayed
(Read-Only)	per screen with a maximum of 4 columns. The list of ports can include
	both physical and virtual ports. If the number of ports exceed these
	limits, one or more other screens may be accessed using the NEXT
	and PREVIOUS commands.
Priority	Select a default priority from 0 to 7 for each port. When the screen is
(Selectable)	displayed the current default priority settings are shown for each port.
	For details, refer to Section 8.2.1.
Policy Override	View any active policy override.
(Read-Only)
Set	Set the priority for one port or set all the ports to the same priority.
(Toggle)	This field toggles between INDIVIDUAL and ALL PORTS.
	INDIVIDUAL is the default setting.
	When set to INDIVIDUAL, the priority of various ports may be
	changed individually and saved.
	When set to ALL PORTS, a Priority field displays to the right of the
	Set field, and the SAVE command changes to SAVE ALL. This allows
	you to select one priority and apply it to all ports. For details, refer to
	Section 8.2.2.

8.2.1Setting Switch Port Priority Port-by-Port

To set the default port priority on a particular port, proceed as follows:

1.Use the arrow keys to highlight the Set field.

2.Press the SPACE bar to step to the INDIVIDUAL setting.

3.Use the arrow keys to highlight the Priority field for the particular port.

4.Press the SPACE bar to step to the appropriate value: 0 through 7.

5.If more than one port is to be changed, repeat steps 3 and 4 to change the setting for each port, then perform step 6 to save all the changes.

6.Use the arrow keys to highlight the SAVE command at the bottom of the screen.

7.Press ENTER. The message “SAVED OK” displays and the setting is saved.

8-6802.1p Configuration Menu Screens