11.2 Introduction

This section describes the timer interface module (TIM2, Version B). The TIM is a two-channel timer that provides a timing reference with input capture, output compare, and pulse-width-modulation functions. Figure 11-1is a block diagram of the TIM.

11.3 Features

Features of the TIM include the following:

•Two Input Capture/Output Compare Channels

–Rising-Edge, Falling-Edge, or Any-Edge Input Capture Trigger

–Set, Clear, or Toggle Output Compare Action

•Buffered and Unbuffered Pulse Width Modulation (PWM) Signal Generation

•Programmable TIM Clock Input

–Seven-Frequency Internal Bus Clock Prescaler Selection

–External TIM Clock Input (4-MHz Maximum Frequency)

•Free-Running or Modulo Up-Count Operation

•Toggle Any Channel Pin on Overflow

•TIM Counter Stop and Reset Bits

•Modular Architecture Expandable to Eight Channels

Advance Information

MC68HC(7)08KH12 — Rev. 1.1

 

 

162

Freescale Semiconductor

Page 161 Page 163
Page 162
Image 162
Freescale Semiconductor MC68HC08KH12 manual Introduction, 162
Page 161 Page 163

MC68HC08KH12 specifications

The Freescale Semiconductor MC68HC08KH12 is a versatile microcontroller that has gained popularity in various embedded systems applications. Part of the HC08 family, this microcontroller combines a robust architecture with comprehensive on-chip features, making it suitable for a wide range of applications ranging from industrial control to consumer electronics.

One of the main features of the MC68HC08KH12 is its 8-bit architecture, which provides an optimal balance between performance and power efficiency. It operates at clock speeds of up to 2 MHz, allowing for efficient execution of instructions while maintaining low power consumption. The microcontroller is designed to operate over a voltage range of 2.7 to 5.5 volts, making it adaptable to various system requirements.

The MC68HC08KH12 is equipped with 1 Kbyte of RAM and 12 Kbytes of ROM, which allows for substantial program and data storage. The on-chip memory helps reduce the need for external components, simplifying the design of embedded systems and enhancing reliability. With a wide range of I/O options, including 26 general-purpose I/O pins, the microcontroller provides flexibility in interfacing with sensors, actuators, and other devices.

In terms of technologies, the MC68HC08KH12 features an advanced instruction set that enhances programming efficiency. It supports basic arithmetic operations, bit manipulation, and control transfer instructions, making it suitable for a variety of computational tasks. The integrated timers, analog-to-digital converters, and serial communication interfaces, including UART, provide the necessary tools for real-time control and data exchange with peripheral devices.

Another characteristic of the MC68HC08KH12 is its low power mode capabilities, which allow it to enter a sleep state during periods of inactivity. This feature is essential in battery-powered applications, where minimizing power consumption is crucial for extending operational life.

Overall, the Freescale Semiconductor MC68HC08KH12 stands out as a reliable microcontroller that combines performance, flexibility, and power efficiency. Its extensive features and technologies enable engineers to design robust embedded systems that meet the demands of modern applications. As a result, the MC68HC08KH12 remains a valuable choice for developers seeking a highly functional yet cost-effective microcontroller solution.
Top Page Image Contents