SMV 3000 Transmitter User’s Manual 173

2. Flow - PV4 - Configuration Section

(If using SMV 3000 for PV1, PV2 and PV3 measurement only, do not complete flow section.)

(If you are using a primary element that is not listed, use the Standard Flow Equation Section below.)

Orifice - Flange Taps (ASME-ISO) D >/= 2.3 inches Orifice - Flange Taps (ASME-ISO) 2 </= D </= 2.3 Orifice - Corner Taps (ASME-ISO)

Orifice - D and D/2 Taps (ASME-ISO) Orifice - 2.5D and 8D Taps (ASME-ISO) Venturi - Machined Inlet (ASME-ISO) Venturi - Rough Cast Inlet (ASME-ISO)

Venturi - Rough Welded Sheet-Iron Inlet (ASME-ISO) Nozzle (ASME Long Radius)

Venturi nozzle (ISA Inlet) Leopold venturi Gerand venturi Universal Venturi Tube Lo-Loss Venturi Tube Preso Ellipse Ave. Pitot Tube

_____

_____ (Liquids only)

_____ (Specify 7/8”, 1.25” or 2.25” Probe diameter)

Flow Data: (obtained from Primary Element Sizing Sheet)

Design Pressure __________________ (required only for Gas applications)

Design Temperature ________________ (required only for Gas applications)

Design Density ___________________ (required only for Steam applications)

Standard Density __________________ (required only for Standard Volume equations)

Fluid Name:	________________________________________________
Pipe Properties:	Material __________	Pipe Schedule ______	Pipe Diameter _________
Isentropic Exponent:	_____________ (not required for Liquid applications or Pitot Tube)

(Standard equation should be used for any primary element not listed in Dynamic Flow Section above.)

Fluid State:	Gas _____	Liquid _____		Steam _____
Fluid Name:	________________________________________________
Flow Data: (obtained from Primary Element Sizing Sheet)
Normal Flowrate __________________		Design Pressure	_____________(Gas applications only)

Normal Diff. Pressure_________________ Design Temperature ________________ (Gas applications only)

Design Density ___________________ (required only for Steam and Liquid applications)

Standard Density __________________ (required only for Standard Volume equations)

Flow Compensation:

None ___

Full ___ Pressure Only ___ Temperature Only___

Continued on next page

1/99

Honeywell user manual SMV 3000 Transmitter User’s Manual 173