HP Pro 4300 B5P90UT#ABA, D8C84UT#ABA Installing an Optical Drive into the 5.25-inch Drive Bay

Installing an Optical Drive into the 5.25-inch Drive Bay

To install an optional 5.25-inch optical drive:

1.Prepare the computer for disassembly (Preparation for Disassembly on page 37).

2.Remove the access panel (Computer Access Panel on page 39).

3.If you are installing a drive in a bay covered by a bezel blank, remove the front bezel then remove the bezel blank. See Bezel Blanks on page 41 for more information.

4.Install three M3 metric mounting screws in the lower holes on each side of the drive: two on the right side and one on the front left side. HP has provided extra M3 metric mounting screws on the front of the chassis, under the front bezel. The M3 metric mounting screws are black. Refer to Installing and Removing Drives on page 55 for an illustration of the extra M3 metric mounting screws location.

CAUTION: Use only 5-mm long screws as mounting screws. Longer screws can damage the internal components of the drive.

NOTE: When replacing the drive, transfer the three M3 metric mounting screws from the old drive to the new one.

Figure 7-21Installing Mounting Screws in the Optical Drive

5.Position the mounting screws on the drive into the J-slots in the drive bay. Then slide the drive toward the front of the computer until it stops.

Figure 7-22Installing the Optical Drive

Drives 59