Diagnostics passes, but the computer does not communicate with the network.

Cause

Solution

Network drivers are not loaded, or driver parameters do not match current configuration.

Make sure the network drivers are loaded and that the driver parameters match the configuration of the network controller.

Make sure the correct network client and protocol is installed.

The network controller is not configured for this computer.

Select the Network icon in the Control Panel and configure the network controller.

Network controller stopped working when an expansion board was added to the computer.

Cause

Solution

 

 

Network controller interrupt is shared with an expansion

Under the Computer Setup Advanced menu, change the

board.

resource settings for the board.

 

 

The network controller requires drivers.

Verify that the drivers were not accidentally deleted when the

 

drivers for a new expansion board were installed.

 

 

The expansion board installed is a network card (NIC) and

Under the Computer Setup Advanced menu, change the

conflicts with the embedded NIC.

resource settings for the board.

 

 

Network controller stops working without apparent cause.

Cause

Solution

 

 

The files containing the network drivers are corrupted.

Reinstall the network drivers, using the Recovery Disc Set

 

created from the hard drive's Recovery Partition.

 

 

The cable is not securely connected.

Ensure that the cable is securely attached to the network

 

connector and that the other end of the cable is securely

 

attached to the correct device.

 

 

The network controller is defective.

Contact an authorized service provider.

 

 

New network card will not boot.

 

 

 

Cause

Solution

New network card may be defective or may not meet industry-standard specifications.

Install a working, industry-standard NIC, or change the boot sequence to boot from another source.

Cannot connect to network server when attempting Remote System Installation.

Cause

Solution

The network controller is not configured properly.

Verify Network Connectivity, that a DHCP Server is present, and that the Remote System Installation Server contains the NIC drivers for your NIC.

Solving Network Problems 125

Page 133
Image 133
HP D8C84UT#ABA, D3K21UT#ABA, D3K19UT D3K19UT#ABA, Pro 4300 C9H67UT#ABA manual New network card will not boot Cause Solution