HP D3K21UT#ABA manual Table C-12Solving Memory Problems, Out of memory error Cause Solution

Models: D8C84UT#ABA D3K21UT#ABA D3K19UT D3K19UT#ABA Pro 4300 C9H69UT#ABA Pro 4300 B8T87UT B8T87UT#ABA Pro 4300 B5P90UT#ABA Pro 4300 C9H67UT#ABA

1 160
Download 160 pages 41.85 Kb
Page 134
Image 134

System setup utility reports unprogrammed EEPROM.

Cause

Solution

 

 

Unprogrammed EEPROM.

Contact an authorized service provider.

 

 

Solving Memory Problems

If you encounter memory problems, some common causes and solutions are listed in the following table.

CAUTION: Power may still be supplied to the DIMMs when the computer is turned off (depending on the Management Engine (ME) settings). To avoid damage to the DIMMs or the system board, you must unplug the computer power cord before attempting to reseat, install, or remove a DIMM module.

For those systems that support ECC memory, HP does not support mixing ECC and non-ECC memory. Otherwise, the computer will not boot the operating system.

NOTE: The memory count will be affected by configurations with the Management Engine (ME) enabled. The ME uses 8MB of system memory in single channel mode or 16MB of memory in dual- channel mode to download, decompress, and execute the ME firmware for Out-of-Band (OOB), third- party data storage, and other management functions.

Table C-12Solving Memory Problems

System will not boot or does not function properly after installing additional memory modules.

Cause

Solution

 

 

A memory module is not installed in the XMM1 (or DIMM1)

Ensure that a memory module is installed in the black XMM1

socket.

(or DIMM1) socket on the system board. This socket must be

 

populated with a memory module.

 

 

Memory module is not the correct type or speed grade for

Replace module with the correct industry-standard device for

the system or the new memory module is not seated

the computer. On some models, ECC and non-ECC memory

properly.

modules cannot be mixed.

 

 

Out of memory error.

 

 

 

Cause

Solution

 

 

Memory configuration may not be set up correctly.

Use the Device Manager to check memory configuration.

 

 

You have run out of memory to run the application.

Check the application documentation to determine the

 

memory requirements.

 

 

Memory count during POST is wrong.

 

 

 

Cause

Solution

 

 

The memory modules may not be installed correctly.

Check that the memory modules have been installed

 

correctly and that proper modules are used.

 

 

Integrated graphics may use system memory.

No action required.

 

 

126 Appendix C Troubleshooting Without Diagnostics

Page 134
Image 134
HP D3K21UT#ABA, D8C84UT#ABA, D3K19UT D3K19UT#ABA Table C-12Solving Memory Problems, Out of memory error Cause Solution