HP Pro 4300 B8T87UT B8T87UT#ABA, D8C84UT#ABA, D3K21UT#ABA, D3K19UT D3K19UT#ABA, Pro 4300 C9H67UT#ABA

8.Align the mounting screws with the slots on the chassis drive cage, press the hard drive down into the bay, then slide it back until it stops and locks in place.

Figure 7-40Installing the Hard Drive

9.Connect the power and data cables to the back of the hard drive.

NOTE: When replacing the primary hard drive, be sure to route the SATA and power cables through the cable guide on the bottom of the chassis frame behind the hard drive.

The data cable must be connected to the dark blue connector labeled SATA0 on the system board to avoid any hard drive performance problems.

10.Rotate the drive cage for internal drives and the power supply down to their normal positions.

11.Replace the access panel.

12.If the computer was on a stand, replace the stand.

13.Reconnect the power cord and turn on the computer.

14.Lock any security devices that were disengaged when the access panel was removed.

68 Chapter 7 Removal and Replacement Procedures Small Form Factor (SFF) Chassis