HP MFP Sending Software 4.9X manual Novell login required, Login, Refine your search

Table 4-2Device control-panel messages (continued)

Message	Description and actions
No Send Options are currently available	No licensed DSS services are available, and the device is
	not configured for embedded e-mail or fax capabilities.
	1.	Use the Configuration Utility to enable one or more
		send options.
	2.	Restart the DSS service.
	3.	Use the Configuration Utility to verify that the license for
		the device was typed correctly.
	4.	Use the Configuration Utility to configure embedded
		e-mail.
Novell login required	The device has been configured to require a Novell login in
	order to use the selected feature.
Password or name is incorrect. Please enter correct	The username or password is incorrect or was mistyped.
login.	Retype the username and password.
	Verify that the settings on the Authentication tab of the
	Configuration Utility are correct for the network.
The Digital Sending Service at 15.XX.YY.ZZ does not	The license for the device was removed from the Digital
service this device. Contact administrator.	Sending service at the TCP/IP address 15.XX.YY.ZZ, but the
	service was able to communicate with the device. Therefore,
	the device was not notified that it was no longer licensed.
	When this error occurs, the device is updated to indicate that
	it is not licensed by a Digital Sending service, so the
	message will only appear once.
	Relicense the device.
Too many addresses were found to display. Please	When the user initiated an address-book search, the number
refine your search.	of addresses in the address book that matched the search
	criteria was more than the device could show on the control-
	panel display.
	Refine the search by typing more characters before starting
	the search function.
The folder you have entered is not a valid folder.	The device was unable to validate the path that was typed
	for the Send to Folder feature. Verify that the correct path is
	being used.

Unable to send Fax. Please check fax configuration.

The fax accessory must be configured before faxing can take place.

Configure the fax accessory by using the Configuration Utility, or enable faxing by using the DSS service. Resend the fax job.

ENWW Control panel messages 121