9 SCANS

■Programmed scan operation

[SQL]

PROG

EXIT/SET

Main dial

F-1

■∂F scan operation

[SQL]

∂F

∂F SCAN EXIT/SET Main dial

F-2 F-4

qPush EXIT/SET several times to close a multi-func- tion screen, if necessary.

wSelect VFO mode.

eSelect the desired operating mode.

•The operating mode can also be changed while scan- ning.

rPush [F-5•SCAN] to select the scan screen. t Set [SQL] open or closed.

•See page 9-2 for squelch condition.

yPush [F-1•PROG] to start the programmed scan.

•“ PROGRAM SCAN ” and decimal points blink while scanning.

uWhen the scan detects a signal, scan stops, pauses or ignores it depending on the resume setting and the squelch condition.

i To cancel the scan, push [F-1•PROG].

• Rotating the main dial also cancels the scan.

oPush and hold [F-6•RECALL] for 1 sec. to recall the frequency that is set before starting the scan, if de- sired.

If the same frequencies are programmed into the scan edge memory channel P1 and P2, pro- grammed scan will not start.

qPush EXIT/SET several times to close a multi-func- tion screen, if necessary.

wSelect VFO mode or a memory channel. e Select the desired operating mode.

•The operating mode can also be changed while scan- ning.

rPush [F-5•SCAN] to select the scan screen. t Set the main band’s [SQL] open or closed.

•See page 9-2 for squelch condition.

ySet the ∂F span by pushing [F-4•∂F SPAN].

•±5 kHz, ±10 kHz, ±20 kHz, ±50 kHz, ±100 kHz, ±500 kHz and ±1000 kHz are selectable.

uSet center frequency of the ∂F span. i Push [F-2•∂F] to start the ∂F scan.

•“ :F SCAN ” and decimal points blink while scanning. oWhen the scan detects a signal, the scan stops, pauses or ignores it depending on the resume set-

ting and the squelch condition. !0To cancel the scan, push [F-2•∂F].

•Rotating the main dial also cancels the scan.

!1Push and hold [F-6•RECALL] for 1 sec. to recall the frequency that was set before starting the scan.

9-4