PRECAUTIONS

RWARNING HIGH RF VOLTAGE! NEVER

attach an antenna or internal antenna connector during transmission. This may result in an electrical shock or burn.

RWARNING! NEVER operate the transceiver with a headset or other audio accessories at high vol- ume levels. Hearing experts advise against continuous high volume operation. If you experience a ringing in your ears, reduce the volume or discontinue use.

RCAUTION! NEVER change the internal set- tings of the transceiver. This may reduce transceiver performance and/or damage to the transceiver.

In particular, incorrect settings for transmitter circuits, such as output power, idling current, etc., might damage the expensive final devices.

The transceiver warranty does not cover any problems caused by unauthorized internal adjustment.

RCAUTION! NEVER touch the transceiver top cover when transmitting continuously for long periods. The top cover may be hot.

RCAUTION! NEVER let metal, wire or other ob- jects protrude into the transceiver or into connectors on the rear panel. This may result in an electric shock.

RCAUTION! NEVER block any cooling vents on the top, rear or bottom of the transceiver.

RCAUTION! NEVER expose the transceiver to rain, snow or any liquids.

RCAUTION! NEVER install the transceiver in a place without adequate ventilation. Heat dissipation may be reduced, and the transceiver may be dam- aged.

RCAUTION! NEVER operate or touch the trans- ceiver with wet hands. This may result in an electric shock or damage to the transceiver.

RCAUTION! The transceiver weighs approx. 22.5 kg (50 lb). Always have two people available to carry, lift or turn over the transceiver.

RCAUTION! The line-voltage receptacle must be near the transceiver and must be easily accessible. Avoid extension cords.

DO NOT use chemical agents such as benzine or alcohol when cleaning the IC-7700, as they can damage the transceiver’s surfaces.

DO NOT push the PTT switch when you don’t actually desire to transmit.

AVOID using or storing the transceiver in areas with temperatures below ±0°C (+32°F) or above +50°C (+122°F).

AVOID placing the transceiver in excessively dusty environments or in direct sunlight.

AVOID placing the transceiver against walls or putting anything on top of the transceiver. This may overheat the transceiver.

Always place unit in a secure place to avoid inadvertent use by children.

BE CAREFUL! If you use a linear amplifier, set the transceiver’s RF output power to less than the linear amplifier’s maximum input level, otherwise, the linear amplifier will be damaged.

Use Icom microphones only (supplied or optional). Other manufacturers’ microphones have different pin assignments, and connection to the IC-7700 may damage the transceiver or microphone.

The LCD display may have cosmetic imperfections that appear as small dark or light spots. This is not a malfunction or defect, but a normal characteristic of LCD displays.

During maritime mobile operation, keep the transceiver and microphone as far away as possible from the magnetic navigation compass to prevent erroneous indica- tions.

Turn [I/O] switch (on the rear panel) OFF and/or disconnect the AC power cable from the AC outlet when you will not use the transceiver for long period of time.

For U.S.A. only

CAUTION: Changes or modifications to this device, not expressly approved by Icom Inc., could void your authority to operate this device under FCC regulations.

ii