Intel IXP43X DDR - Write Preamble/Postamble Duration, DDRII-400 MHz Interface -- Signal Timings

Intel® IXP43X Product Line of Network Processors—Hardware Design Guidelines

Figure 31. DDR - Write Preamble/Postamble Duration

DQS

TVB6

DQS

TVA6

Table 30.			DDRII-400 MHz Interface -- Signal Timings
Symbol			Parameter	Minimum	Nominal	Maximum	Units	Notes
TVB1		DQ, CB and DM write output valid time before DQS.		521			ps	1
TVA1		DQ, CB and DM write output valid time after DQS.		521			ps	1
TVB3		Address and Command write output valid before CK		1771			ps	1, 4
		rising edge.
TVA3		Address and Command write output valid after CK rising		1771			ps	1, 4
		edge.
TVB4		DQ, CB and DM read input valid time before DQS rising		323			ps	2
		or falling edges.
TVA4		DQ, CB and DM read input valid time after DQS rising or		323			ps	2
		falling edges.
TVB5		CS_N[1:0] control valid before CK rising edge.		1771			ps	4
TVA5		CS_N[1:0] control valid after CK rising edge.		1771			ps	4
TVB6		DQS write preamble duration.			3750		ps	3
TVA6		DQS write postamble duration.			2500		ps	3
TV7		DQ, CB, and DM pulse width (tDIPW)			1750		ps	1
Notes:
1.	See Figure 29, “DDR SDRAM Write Timings” on page 77
2.	See Figure 30, “DDR SDRAM Read Timings” on page 77. The specified minimum requirements for the “Data to strobe
	read setup” and “Data from strobe read hold” are determined with the DQS delay programmed for 90 degree phase
	shift.
3.	See Figure 31, “DDR - Write Preamble/Postamble Duration” on page 78
4.	Address/Command pin group; RAS_N, CAS_N, WE_N, MA[13:0], BA[1:0]
5.	Designed to JEDEC specification; it is recommended that IBIS models should be used to verify signal integrity on
	individual designs

Intel® IXP43X Product Line of Network Processors
HDG	April 2007
78	Document Number: 316844; Revision: 001US