Management module error messages
✏ NOTE
See Chapter 6, “SBCEFCSW / SBFCM Parts listing,” on page 153 to determine which components should be replaced by a field service technician.
Message | Action |
|
|
Application posted alert to ASM | The alert button on the web interface was tested. Information only. |
| Take action as required. |
|
|
System log 75% full | Information only. Take action as required. |
|
|
System log full | Information only. Take action as required. |
|
|
Management module network | Information only. Take action as required. |
initialization complete |
|
|
|
Remote login successful. Login ID | Information only. Take action as required. |
|
|
ASM reset was caused by restoring | The management module assembly was reset after restoring the |
default values | default settings. Information only. Take action as required. |
|
|
ASM reset was initiated by the user | Information only. Take action as required. |
|
|
Pushbutton reset activated: Ethernet | 1. Reseat the management module. |
configuration reset to default values and | 2. Reflash the management module firmware. |
MM ASM reset due to watchdog timeout | 3. Replace the management module. |
|
|
ASM reset due to XXXXX, instruction | 1. Reseat the management module. |
fault: XXXXXXXX YYYYYYYY ZZZZZZ | 2. Reflash the management module firmware. |
| 3. Replace the management module. |
|
|
ASM reset reason unknown | Information only. |
|
|
Possible ASM reset occurred reason | Information only. |
unknown |
|
|
|
Remote access attempt failed. Invalid | Failed attempt to log into the management module. |
userid or password received. User is |
|
XXX from CMD mode client at |
|
IP@=XXX.XXX.XXX.XXX |
|
|
|
Remote access attempt failed. Invalid | Failed attempt to log into the management module. |
userid or password received. User is |
|
XXX from WEB browser |
|
IP@=XXX.XXX.XXX.XXX |
|
|
|
DHCP [X] failure, no IP @ assigned | Failed to get IP address by DHCP server. Check the DHCP server |
(retry X), rc=X | connection and settings. |
|
|
LAN: Command mode tamper triggered. | Unsuccessful attempt to access the management module in |
Possible break in attempt. | command mode. Information only. Take action as required. |
|
|
LAN: WEB server tamper delay | Unsuccessful attempt to access the management module in |
triggered. Possible break in attempt. | command mode. Information only. Take action as required. |
|
|
System log cleared. | Information only. Take action as required. |
|
|
148Intel Blade Server Fibre Channel Switch Module SBCEFCSW / FC Expansion Card SBFCM Guide
