Intel SBCEFCSW, SBFCM manual SNMP trap configuration, SNMP configuration parameters

Table 34. SNMP configuration parameters

Parameter	Description
Contact	Specifies the name of the person to contact for trap events. The default is
	undefined.
Read community	Read Community Authentication. A write-only field; the value on the switch
	module and the SNMP management server must be the same. The default value
	is Public.
Trap community	Trap Community Authentication. A write-only field; the value on the switch
	module and the SNMP management server must be the same. The default value
	is Public.
Location	Specifies the switch module location. The default is undefined.
Authentication trap	Enables or disables the reporting of SNMP authentication failures. If enabled,
	and the incorrect community string values are used, an authentication failure
	event occurs and a notification trap is sent to the configured trap addresses. The
	default value is False.
Write community	Write Community Authentication. A write-only field; the value on the switch
	module and the SNMP management server must be the same. The default value
	is Private.

SNMP trap configuration

The SNMP trap configuration defines how traps are set. Table 35 describes the SNMP trap configuration parameters.

Table 35. SNMP trap configuration parameters

Parameter	Description
Trap enabled	Select this check box to enable or disable the trap.
Trap address	Specifies the IP address to which SNMP traps are sent. The default is 10.0.0.1
	for trap 1 and 0.0.0.0 for traps 2–5. A maximum of five trap addresses are
	supported.
Trap port	The port number on which the trap is set.
Trap severity	Specifies a severity level to assign to the trap. Open the menu and select a
	level. Traps must be enabled to access this menu. Trap severity levels include
	Unknown, Emergency, Alert, Critical, Error, Warning, Notify, Info, Debug, and
	Mark.

Restoring Fibre Channel switch module configuration

This section describes switch module configuration restoration tasks that are performed using the Telnet CLI interface and the management module.

119