5.5 Replacing Parts
5. Remove the pick roller from the shaft.
Lift up the lock tab and slide the pick roller off the shaft.
ATTENTION
Take care if lifting the pick roller lock tab with your fingernail as it may get chipped or broken. If worried, try lifting the tab using a paper clip as shown in the following diagram.
1
2
6. Attach the new pick roller.
Insert the shaft into the new pick roller, aligning the protruding pin on the shaft with the matching notch in the pick roller.
5
ATTENTION
Pin on shaft | Pick roller notch |
Make sure that the pick roller shaft is fully inserted. If it is not correctly attached, document jams and other feeding errors may occur. You should hear a "click" when the pick roller shaft is inserted correctly. Make sure you hear this noise when inserting the shaft into the pick roller.
"Click"
Care Scanner
Network Scanner |
| 223 |
| ||
|
|
|