Juniper Networks fi-6000NS manual 335

Code	Message	Action
12010001	Scanned data size exceeded	Try the following:
	maximum size allowed for	• Reduce the number of pages to be
	e-mail attachments.	scanned and send the e-mail in separate
		parts.
		• Select a higher compression level and
		try again.
		"4.7.8 Compression" (page 188)
		If the problem persists, contact a system
		administrator to check the "Maximum
		Attachment Size" setting.
		"3.6.6 Setting the e-Mail Server (SMTP	C
		Server)" (page 69)
12010002	Could not connect to server	Try the following:
	when sending e-mail.	• Check that the LAN cable of the scanner
		and SMTP server is connected properly.
		• Contact a system administrator to check
		that then scanner IP address and SMTP
		server settings are correct.
		"6.3 Network Connection
		Troubleshooting" (page 234)
		• Contact a system administrator to check
		that the SMTP server is working
		properly.
12010003	"From" address was rejected by	Contact a system administrator to check
	the server when sending e-mail.	that the specified e-mail source address is
		authorized for use on the server.
12010004	"To" address was rejected by	Contact a system administrator to check
	the server when sending e-mail.	that the specified e-mail destination
		address is authorized for use on the server.
12010005	e-Mail size exceeded maximum	Contact a system administrator to check
	e-mail size allowed by the	the maximum e-mail size allowed by the
	SMTP server.	SMTP server.

Network Scanner fi-6000NS Operator's Guide 309