Konica Minolta 7135, 7130 manual Action, Wait until the current operation is completed

When “Memory Full” Message Is Displayed (Memory Overflow)

In certain modes, this printer/copier uses memory to make operations convenient and smooth flowing. Occasional memory overflow may occur if the installed memory is inadequate for the copy conditions selected.

To handle the Memory overflow condition while performing a job, take the appropriate action described below. These actions enable you to continue the job or suspend the job.

•Copying in Group mode without Store mode selected . . . . . . . Action 1

•Copying under conditions other than the above . . . . . . . . . . . . Action 2

DETAILS

Should memory overflow occur frequently, it is recommended that you contact your service representative to extend the memory capacity in your machine.

Action 1

Action 1 is required when the machine prematurely stops copying and displays the Memory Overflow message after producing only one copied set, irrespective of the print quantity setting.

1. Wait until the current operation is completed.

The following Memory Overflow message is displayed on the touch screen, and all the data in memory is erased.

If continuous working check output after copying

2. Check the original pages, then position originals again.

DETAILS

Positioning the same number of originals may cause the memory overflow again. Arrange the original pages to lighten a burden to memory.

3. Press [START] to complete the job.

5-10