Konica Minolta 7130, 7135 manual Interrupt Copying, Set copy conditions, as desired

Interrupt Copying (continued)

DETAILS

In Reserve mode, pressing [INTERRUPT] before the copier finishes scanning the reserve job originals clears the settings selected for the reserve job.

For details of Reserve mode, see p. 3-27 to p. 3-28.

2. Set copy conditions, as desired.

The initial settings in Interrupt mode are as follows.

Copy Mode	: 1a1
RADF	: ON
AES	: ON
Lens Mode	: 1.00 (100%)
APS	: ON
Print Quantity	: 1
Finisher	: Exit Tray 1 in Sort mode

DETAILS

Remove any document from the platen glass or from the document feeder, if present.

3. Position original(s).

HINT

See p. 3-2 to p. 3-6 for details on positioning originals.

4. Press [START] to start the interrupt copying.

DETAILS

When [CHECK] is pressed during Interrupt copying, the information displayed reflects the initial copy job settings. Check mode will not display Interrupt copy job information.

5. When Interrupt copying is completed, press [INTERRUPT] again.

The [INTERRUPT] LED turns out and the INTERRUPT indicator on the Basic Screen returns to the SETTING indicator.

The settings of the initial job will be restored on the Basic Screen.

6. Press [START] to resume copying.

CAUTION

When the finisher / paper exit / inner tray capacity is exceeded due to the print quantity selected, remove the copied sets as they exit; otherwise, mishandled paper will occur.

3

Copying Operations

Positioning

Originals

Setting Print

Quantity

Copy Size

Lens Mode

Density

1-1, 2-2

2-1

Using

Memory

Output without

Finisher

FS-107

Output Modes

IT-101

Output Modes

Check Mode

&Proof Copy

Interrupt

Mode

3-45