Kyocera 3035 manual Copy eject location, Select Copy output mode, Inner tray

Section 7 COPIER MANAGEMENT FUNCTIONS

●Copy eject location

Perform the following procedure to set where finished copies will be ejected.

NOTE

This setting will only be displayed when the optional Document Finisher, Built-in Finisher or Job Separator is installed on your copier.

1Display the “Machine default” screen.

(See “(2) Accessing the machine default settings” on page 7-41.)

Inch specifications

Default setting / Counter

Default setting				End
Copy		Language	Management
default
		Bypass	BOX	Counter
		setting	Management	check
Machine	Document	Register	Print	User
default	Management	orig. size	report	Adjustment

Metric specifications

Default setting / Counter

Default setting				End
Copy		Language	Management
default
		Bypass	Hard Disk	Counter
		setting	Management	check
Machine	Document	Register	Print	User
default	Management	orig. size	report	Adjustment

2Select “Select Copy output mode” in the settings list on the left side of the touch panel and then touch the “Change #”

key.

The “Select Copy output mode” screen will be displayed. Inch specifications

Default setting / Counter

Machine default		Close
Default menu	Setting mode	Up
Sleep mode changing time	60 Minute
Low power mode chng. time	15 Minute	Down
Select Copy output mode	Inner tray
Select FAX output mode	Inner tray
Select the main mode	Copy mode	Change #
Default setting

Metric specifications

Default setting / Counter

Machine default		Close
Default menu	Setting mode	Up
Sleep mode changing time	60 Minute
Low power mode chng. time	15 Minute	Down
Select COPY output mode	Inner tray
Select FAX output mode	Inner tray
Select main mode	COPY Mode	Change #
Default setting

3Touch the key that corresponds to the desired location. Inch specifications

Select Copy output mode Back Close

Set the default copy output destination

Job separator

Inner tray

Finisher main tray

Finisher sub tray

Default setting - Machine default

Metric specifications

Select COPY output mode Back Close

Set the default copy output destination.

Job separator

Inner tray

Finisher main tray

Finisher sub tray

Default setting - Machine default

NOTES

•The available location for ejection will differ depending upon the optional equipment that is installed on your copier.

•If you want to quit the displayed setting without changing it, touch the “Back” key. The touch panel will return to the screen in step 2.

4Touch the “Close” key. The touch panel will return to the screen in step 2.

5Touch the “Close” key once again. The touch panel will return to the “Default setting”screen.

6Touch the “End” key. The touch panel will return to the contents of the “Basic” tab.

7-49