Kyocera 3035 manual Making copies with clean edges Border erase modes

Section 5 OTHER CONVENIENT FUNCTIONS

6. Making copies with clean edges [Border erase modes]

(1)Erasing blemishes from edges of copies (Sheet erase mode)

Inch specifications

With this mode, shadows, lines, etc., that occur around the edges of copies made from sheet originals can be erased. A border of equal width will be erased around all sides of the copied image. The width of the border to be erased can be set to any 1/8" increment between 1/8" and 3/4". A setting of “0” will result in no border being erased. (The areas that will be erased are shown as a in the illustration.) Metric specifications

With this mode, shadows, lines, etc., that occur around the edges of copies made from sheet originals can be erased. A border of equal width will be erased around all sides of the copied image. The width of the border to be erased can be set to any 1 mm increment between

1 mm and 18 mm. A setting of “0” will result in no border being erased. (The areas that will be erased are shown as a in the illustration.)

a

a

(2)Erasing blemishes from the edges and middle of copies made from books (Book erase mode)

Inch specifications

With this mode, you can make clean copies, even from thick books. The width of the outside border to be erased can be set to any 1/8" increment between 1/8" and 3/4". The width of the center area to be erased can be set to any 1/8" increment between 1/8" and 1 1/2".

A setting of “0” will result in no border being erased.

(The area that will be erased as the outside border is shown as a in the illustration, while that of the center area is shown as b.)

Metric specifications

With this mode, you can make clean copies, even from thick books. The width of the outside border to be erased can be set to any 1 mm increment between 1 mm and 18 mm. The width of the center area to be erased can be set to any 1 mm increment between 1 mm and

36 mm. A setting of “0” will result in no border being erased.

(The area that will be erased as the outside border is shown as a in the illustration, while that of the center area is shown as b.)

abcdefghijk
abcdefghijk
abcdefghijk
abcdefghijk
abcdefghijk
abcdefghijk
abcdefghijk
abcdefghijk		abcdefghijk
	a	abcdefghijk
		abcdefghijk
		abcdefghijk
a	b	abcdefghijk
		abcdefghijk
		abcdefghijk
		abcdefghijk
		abcdefghijk

NOTE

It is possible for you to change the default setting for the width of the erased border. (See “Erased border width” on page 7-81.)

NOTE

It is possible for you to change the default setting for the width of the erased borders. (See “Erased border width” on page 7-81.)

5-11