Kyocera 3035 4How to set originals in the Document Processor, 5How to set originals on the platen

Section 8 OPTIONAL EQUIPMENT

4How to set originals in the Document Processor

1Adjust the original insertion guides to the original size.

NOTE

Before setting the originals in the Document Processor, check that no original from the previous operation is remaining on the original eject cover. Originals remaining on the original eject cover may cause original misfeed.

2Set the originals on the original table in correct sequence with the side to be copied facing upward. Securely insert the

leading edge of the originals into the Document Processor as far as they will go.

*When setting large size paper such as 8 1/2" x 11", A4R or larger, pull out the support extension.

IMPORTANT!

Do not set originals exceeding the limit indicated on the sticker attached on the rear original insertion guide. Setting more originals than specified may cause original misfeed.

5How to set originals on the platen

When using an original that cannot be set in the Document Processor, such as a book or magazine, open the Document Processor and place it on the platen.

1Hold the Document Processor open/close handle and open the Document Processor.

*Before opening the Document Processor, check that no original is present on the original table or original eject cover. If present, the original may fall off when the Document Processor is opened.

2Set the original with the side to be copied facing downward. Be sure to align the original with the original size scales.

8-2