Section 9 TROUBLESHOOTING

3 Misfeed in Built-in Finisher (optional) (JAM 80 to 84)

If the message below appears, a misfeed has occurred in the Built-in Finisher. Remove the misfed paper using the procedure below.

Inch specifications

Paper misfeed.

1.Remove any paper in output part of Finisher

2.Pull the tray of finisher down.

3.Remove the paper if there is a paper.

4.Set the tray

JAM 84

Paper misfeed. Careful for Drum.

1.Lower inner tray of finisher.

2.Remove the paper.

3.Remove the eject tray, open left cover of machine.

4.Remove the paper.

5.Close cover and set the tray.

JAM 83

Metric specifications

Paper misfeed.

1.Remove any paper in output part of Finisher.

2.Put Finisher tray down.

3.Remove any paper.

4.Set tray back.

JAM 84

Paper misfeed. Careful for Drum.

1.Put inner tray of Finisher down.

2.Remove any paper.

3.Remove output tray, open left cover of machine.

4.Remove paper.

5.Close cover and set tray.

JAM 83

NOTE

The drum area inside the copier is extremely sensitive to dirt and damage. When removing the jammed paper, be sure not to touch the drum area that is located inside the machine with your hands, or with jewelry such as watches and rings, etc.

1Removesection. the misfed paper in the Built-in Finisher output

2Lower the Built-in Finisher tray.

3Remove the misfed paper.

4Raise the Built-in Finisher tray back into its original position.

5Remove the tray.

3

1

2

6Pull up the left cover 1 handle to open the left cover 1.

9-11

Page 271
Image 271
Kyocera 3035 manual Misfeed in Built-in Finisher optional JAM 80 to, Paper misfeed. Careful for Drum