Kyocera 3035 manual If one of the following messages is displayed, Message Procedure Reference

Section 9 TROUBLESHOOTING

1. If one of the following messages is displayed

When any of the following messages appears on the message display, take the indicated action.

Message	Procedure	Reference
		page
“Close xxx cover x.”	The cover indicated is open. Close the cover securely.	——
“Add paper in drawer.”	There is no paper in the drawer[cassette] indicated. Load paper.	3-1
[“Add paper in cassette.”]
“Set drawer. ”	One of the drawers[cassettes] is not closed properly. Pull it out and push it back in all	——
[“Close paper cassette.”]	the way.
“Paper drawer is out of order. Select	The drawer[cassette] currently in use is out of order and cannot be used. Contact	——
another paper drawer.”	your service representative immediately. Continue copying using another
[“Paper cassette is out of order. Select	drawer[cassette].
other paper cassette. ”]
“Check paper size.”	No paper that can be used in the selected mode is loaded. Check the paper.	——
“Reposition original.”	The orientation of the original and the selected paper are different. Change the	——
	orientation of the original. If the [Start] key is pressed, same-size copying will be
	performed.
“Exceeds pre registered copying	The number of copies reached the limit set in the copy management mode and no	7-1
quantity.”	more copies can be made. Clear the copy count from the management mode.
[“Copy limit for this ID-code has been
reached. No copying possible.”]
“Ready to copy. Add toner.”	There is not enough toner in the copier. Replace the toner container immediately as	10-3
	only one copy can be made at a time.
“Add toner to resume copying.”	There is not enough toner in the copier to make copies. Replace the toner container	10-3
	immediately.
“System error. Main switch off/on.”	A system error has occurred. Turn the main power switch OFF and then ON.	——
“System error. Disconnect power plug	A system error has occurred. Disconnect the power plug from the outlet and connect	——
from the socket.”	it again.

*If the optional Fax Kit is installed in your copier, when the power cord is unplugged from the outlet, original data or reserved communication information stored in the memory may be lost.

9-1