Kyocera 3035 manual Job Separator, Hard Disk, Clearing a staple jam

Section 8 OPTIONAL EQUIPMENT

2 Clearing a staple jam

1Remove the staple cartridge referring to the “1 Refilling the Stapling Unit”.

Push up on the tab “A” on the protective faceplate in order to raise the faceplate.

A

(8) Job Separator

When using the optional printer function, the paper eject point can be changed according to the used function, making it easier to sort paper.

Copied paper can be ejected to the Job Separator (upper section). See “Copy eject location” in Machine default setting on page 7-49.

*The Job Separator can store up to 100 copies. When making 101 or more copies, copying will stop when 100 copies are made. Copying will resume automatically when the copied sheets are removed.

2

3

4

5

6

Remove the jammed staple from the tip of the staple cartridge (the end where staples are set).

(9) Hard Disk

The Hard Disk is required in order to use the following modes and functions of your copier.

• Job reservation during copying

• Form overlay of registered forms

• Repeat copying

• Document management functions

• Using the output management functions to change the job printing order, cancel and delete print jobs, and verify content

It is also possible to register up to 1000 department ID-codes under

document management.

Lower the protective faceplate back into its original position.

Replace the staple holder back in its original position in the Stapling Unit. Once it has been fully inserted, it will click into place.

Lift up the Stapling Unit slightly and than lower it into its original position.

Close the stapler front cover securely.

8-11