Kyocera 3035 manual If other trouble occurs, Trouble Checkpoint Procedure Reference

Section 9 TROUBLESHOOTING

4. If other trouble occurs

If trouble occurs with your copier, carry out the applicable checkpoints and procedures indicated on the following pages. If the trouble persists, contact your service representative or authorized service center.

Trouble	Checkpoint	Procedure	Reference
			page
Nothing lights on the	Is the power plug connected to an AC	Connect the plug to an AC outlet.	——
operation panel when the	outlet?
main power switch is turned
ON.
No copies come out when	Is there any message appearing on the	Perform the corrective action corresponding	9-1
the [Start] key is pressed.	message display?	to the message.
			-
Copies come out blank.	Are the originals set correctly?	When setting originals on the platen, place	4-1
		them face-down.
		When setting originals in the optional	8-2
		Document Processor, place them face-up.
Copies come out too light.	Is the copier in the auto exposure	To change the overall exposure, perform the	7-73
	mode?	auto exposure adjustment.
	Is the copier in the manual exposure mode?	Adjust the exposure to the correct degree	4-2
		using the copy exposure adjustment keys.
		To change the overall exposure, perform the	7-75
		exposure adjustment for the each copy	7-76
		quality mode.	7-77
	Is the add toner message displayed?	Replace the toner container.	10-3
	Is paper wet?	Replace the paper with new paper.	3-1

9-13