Kyocera 3035 manual 10-6

Section 10 MAINTENANCE AND OPERATION INFORMATION

16 Gently pull out the cleaning shaft (with the green handle) as

far as it will go and then push it back into the copier. Repeat this step a few times.

2

1

IMPORTANT!

Do not pull the cleaning shaft with force or pull it out completely.

17 Remove the blue cleaning brush.

18 Pull up the left cover 1 handle to open the left cover 1.

19 Clean the separator by moving the cleaning brush from left and right several times along the separator as shown in the illustration.

20 Once the cleaning operation is completed, return the cleaning brush to the copier and close both the left cover 1 and the front cover.

IMPORTANT!

Wait about 5 minutes after the cleaning operation is completed for the electrostatic section to dry before attempting to start copying again.

NOTE

To keep the best copying quality, perform cleaning of steps 15 and 18 described above periodically (approximately once a month) in addition to the time of toner container replacement.

●After use, ALWAYS dispose of the toner container and the waste toner box in accordance with Federal, State and Local rules and regulations.

10-6