Leica 1000Z01 user manual Measure ROD Configuration

Meas. Tol : Limit for the difference between the given and measured spacing of the reflectors. If the tolerance value is exceeded, the program will issue a warning.

In case of measurements with 3 prism the values are also used as limit for the max. deviation of the 3 measurements.

Add. const. : Input of prism constant for the prisms of the pole. The prism constant set in the system is disregarded.

No. of Refl. : Number of the reflectors on the rod you are using. Move the input cursor to this line, then toggle to either 2 or 3.

Auto pos. : On the program will automatically point the telescope of a motorized theodolite at the third reflector once the first two reflectors have been measured. The exact pointing must be made manually.

Rod Length : Total length of hidden-point rod.

HP

Space R1-R2 : Spacing between the centers of reflector R1 and reflector R2.

Space R1-R3 : Spacing between the centers of reflector R1 and reflector R3. Enter only for rods with three reflectors. Reflector 3 must be situated between reflector 1 and 2.

Displays date and version of the running application.

Set values to default. Default values are displayed on page 112.

Accept the current configuration and proceed to

"MEASURE ROD"

Note that all parameters for the rod you are using must be defined before you can proceed. If any of the parameters have not been defined, the program will issue an error message to this effect. Press OK to clear the message, then make any necessary settings in the

"CONFIGURATION".

© Leica TPS-System 1000 Programs-2.3.1en 113