Leica 1000Z01 user manual Program concept, Alignment Calculation program only

Program concept	The "ALIGNMENT CALCULATION" program only
	permits measurements in one face.
	Before the program is started, the following procedures
	are carried out:
	1.	Setting user profile and name of the data file.
	2.	Determining the instrument station and the
		orientation

"ROAD STAKEOUT" requires the following input:

1.Chainage for the point to be set out

2.Offset and height displacement of the point to be set out, or zero point of cross section relative to axis (optional)

3.Selection of a point on the cross section (optional)

On the basis of this input, the coordinates of the point to be set out are determined and are transferred to the program "SETTING OUT" for post-processing.

The "X-SECTION CHECK" requires the following input:

1. Measurement to ground point

The parameters calculated and displayed are respectively the chainage, the offset, and the height difference of the point measured with respect to the centre-line.

174 TPS-System 1000 Programs-2.3.1en © Leica