Leica 1000Z01 Use for Ht, Status, Point no, Easting, Northing, Elevation Target coordinates used

2/10	: Sequence number of the current point
	and total number of points in the
	measurement set. The scroll bar shows
	the sequential position of the
	measurements, graphically.
Use for Ht.	: Use this measurement for height
	determination (YES/NO)
Status	: Use this measurement for calculation
	(ON/OFF).
Point no
	: The target point number.
			OH
Error Flag : Identified erroneous measurements.
	Possible values are:
	NONE	measurement is OK
	HZ	horizontal angle error
	DIST	distance error
	HT	height difference error
	The flags may also be combined, i.e.
	DIST + HZ

ΔHz. : Difference between calculated and measured horizontal angle

ΔDistance : Difference between calculated and

measured distance

ΔHeight : Difference between calculated and measured height

Refl. Ht. : Reflector height used for the target point

Easting, Northing, Elevation: Target coordinates used.

Recalculate the result.

Scroll to the measurements of the previous point.

Scroll to the measurements of the following point.

Measure more points. Return to the dialog "Target Point".

Delete a point from the set of measurements. You can now measure a new point in its place.

Exit the program.

© Leica TPS-System 1000 Programs-2.3.1en 33