Leica 1000Z01 user manual Element

Element	: The element type on which the
	chainage displayed is located.
	The elements are output in full. Both
	adjacent elements are displayed in the
	main points.
Offset	: Horizontal displacement (offset) of
	the point to be set out in relation to the
	centre line.

HghtOffset : Height displacement of the point to be set out in relation to the centre line. (The amount of the vertical displacement is also taken into account.)

Hght. Shift : All heights in the alignment are changed by this amount. The value can only be changed in the dialog

"CONFIGURATION".

ChaingeIncr : The chainage difference when setting out. The chainage is automatically incremented by this amount.

Calls the function "X-SECTION CHECK".

Displays the next chainage up which is divisible by ChaingeIncr. If the end of the alignment is overshot, a warning is given once. After the end of the alignment, the calculation is based on the tangent of the last element.

RO

Displays the next chainage down which is divisible by ChaingeIncr. If there is a shortfall at the beginning of the alignment, a warning is given once. Before the beginning of the alignment, the calculation is based on the tangent of the first element.

Calls the dialog "CROSS SECTIONS".

Calls the dialog "POINT COORDINATES" in order to display the coordinates of the point to be set out. From there, calls the program "STAKEOUT".

© Leica TPS-System 1000 Programs-2.3.1en 179