Select this choice to view the system-board identifier, the revision level or issue date of the firmware, the integrated management module and diagnostics code, and the version and date.

This choice is on the full Setup Utility menu only.

vSystem Settings

Select this choice to view or change the server component settings.

Processors

Select this choice to view or change the processor settings.

Memory

Select this choice to view or change the memory settings.

Devices and I/O Ports

Select this choice to view or change assignments for devices and input/output (I/O) ports. You can configure the serial ports; configure remote console redirection; enable or disable integrated Ethernet controllers, the SAS/SATA controller, SATA optical drive channels, and PCI slots. If you disable a device, it cannot be configured, and the operating system will not be able to detect it (this is equivalent to disconnecting the device).

Power

Select this choice to view or change power capping to control consumption, processors, and performance states.

Legacy Support

Select this choice to view or set legacy support.

-Force Legacy Video on Boot

Select this choice to force INT video support, if the operating system does not support UEFI video output standards.

-Rehook INT 19h

Select this choice to enable or disable devices from taking control of the boot process. The default is Disable.

-Legacy Thunk Support

Select this choice to enable or disable UEFI to interact with PCI mass storage devices that are non-UEFI compliant.

Integrated Management Module

Select this choice to view or change the settings for the integrated management module.

-POST Watchdog Timer

Select this choice to view or enable the POST watchdog timer.

-POST Watchdog Timer Value

Select this choice to view or set the POST loader watchdog timer value.

-Reboot System on NMI

Enable or disable restarting the system whenever a nonmaskable interrupt (NMI) occurs. Enable is the default.

-Commands on USB Interface Preference

Select this choice to enable or disable the Ethernet over USB interface on IMM.

-Network Configuration

Select this choice to view the systems-management network interface port, the IMM MAC address, the current IMM IP address, and the host name; define the static IMM IP address, subnet mask, and gateway address;

Chapter 6. Configuring the server 139

Page 157
Image 157
Lenovo 3808 System Settings, Processors, Memory, Devices and I/O Ports, Power, Legacy Support, Force Legacy Video on Boot