Lenovo 3724, 3836, 3809, 3826, 3824, 3808, 3815, 3817 manual Removing and installing drives

Note: You must wait approximately 1 to 3 minutes after you connect the power cord of the server to an electrical outlet before pressing the power-control button.

6. Start the Setup Utility and reset the configuration.

vSet the system date and time.

vSet the power-on password.

vReconfigure the server.

See “Using the Setup Utility” on page 138 for details.

Removing and installing drives

Depending on the server model, the server might come with a SATA attached

DVD-ROM drive in bay 1.

The following are illustrations of the server and the location of the drive bays. Your hardware might differ, depending on the model.

The following illustration shows the location of the drive bays in the 2.5-inch hot-swap SAS or hot-swap SATA hard disk drive server models.

1	Bay 1	7	Bay 3
2	Bay 2	8	Bay 4
3	Bay 3	9	Bay 5
4	Bay 0	10	Bay 6
5	Bay 1	11	Bay 7
6	Bay 2

The following illustration shows the location of the drive bays in the 3.5-inch hot-swap SAS or hot-swap SATA hard disk drive server models.

Chapter 5. Installing optional devices and replacing customer replaceable units 57