–The
-Two single signal cables (thick red and black) that connects to the signal cable connectors on the hard disk drive backplanes and the connectors on the SAS/SATA RAID adapter (see the ServeRAID adapters installation instructions in this document for more cabling information).
-A split power cable (red/yellow/black). The end of the power cable with the single connector connects to the Hard disk drive backplane power connector on the system board and the end of the power cable with the two connectors, connects to the power connectors on the hard disk drive backplanes.
-A split configuration signal cable (black). The end of the configuration signal cable with the single connector connects to the Hard disk drive backplane configuration signal connector on the system board and the end of the configuration signal cable with the two connectors, connects to the configuration signal connectors on the hard disk drive backplanes.
–The
-A single signal cable (thick red and black) that connects to the hard disk drive backplane and one of the connectors on the SAS/SATA RAID adapter (see the ServeRAID adapters installation instructions in this document for more cabling information).
-A single power cable (red/yellow/black) that connects to the Hard disk drive backplane power connector on the system board and to the power connector on the hard disk drive backplane.
-A single configuration signal cable (black) that connects to the Hard disk drive backplane configuration signal connector on the system board and the configuration signal connector on the hard disk drive backplane.
For more information about the requirements for SAS/SATA cables and connecting SAS/SATA devices, see the documentation that comes with these devices.
For a list of supported options for the server, see http://www.lenovo.com/thinkserver.
Removing a power supply
When you remove or install a power supply, observe the following precautions.
Statement 8:
Chapter 5. Installing optional devices and replacing customer replaceable units 79
