Lenovo 3836, 3809, 3826, 3724, 3824, 3808, 3815, 3817 manual Removing a 2.5-inch hot-swap hard disk drive

Removing a 2.5-inch hot-swap hard disk drive

Attention: To maintain proper system cooling, do not operate the server for more than 10 minutes without either a drive or a filler panel installed in each drive bay.

To remove a 2.5-inch hot-swap hard disk drive, do the following:

1.Read the safety information (see “Safety” on page vii and “Installation guidelines” on page 37).

Attention: Static electricity that is released to internal server components when server is powered on might cause the server to halt, which might result in the loss of data. To avoid this potential problem, always use an electrostatic-discharge wrist strap or other grounding system when you work inside the server with the power on.

2.Unlock the side cover.

3.Open the bezel. Place your finger on the pull-point area on the left side of the bezel door and rotate it away from the server.

4.Press the release latch at the top of the drive to release the drive handle.

5.Rotate the handle on the drive upward to the open position.

6.Pull the hot-swap drive out of the bay approximately 25 mm (1 inch). Wait approximately 45 seconds while the drive spins down before you remove the drive completely from the bay.

70ThinkServer TD200 Types 3724, 3808, 3809, 3815, 3817, 3824, 3826, 3836: Installation and User Guide