2Unpacking to Installation
(3) Preparing the T/B
| STATUS NUMBER | CHANG DISP |
|
| EMG.STOP | |||||
|
|
|
|
|
|
|
|
|
|
|
| MODE |
| SVO ON |
| START | RESET |
|
| ||
| TEACH |
|
|
|
|
|
|
|
|
|
AUTO | AUTO |
|
|
|
|
|
|
| ||
(Op.) | (Ext.) |
|
|
|
|
| REMOVE T/B | |||
|
|
| SVO OFF |
| STOP | END |
| |||
|
|
|
|
|
|
|
|
|
|
|
Next, prepare to use the T/B
1) Set the [MODE] switch on the front of the controller to "TEACH".
| MODE |
| TEACH |
AUTO | AUTO |
(Op.) | (Ext.) |
DISABLE ENABLE
DI SABLE | ENABLE |
EMG. STOP
2)Set the T/B [ENABLE/DISABLE] switch to "ENABLE". The menu selection screen will appear.
The following operations are carried out with the T/B.
◇◆◇ Operating from the T/B ◇◆◇
Always set the [MODE] switch (mode selection key switch) on the front of the controller to "TEACH", and then set the T/B [ENABLE/DISABLE] switch to "ENABLE".
When the T/B is valid, only operations from the T/B are possible. Operations from the controller or external signals will not be accepted.
◇◆◇ When T/B operations are mistaken ◇◆◇
The displayed screen will return to the "menu selection screen" when the [MENU] key is pressed. Carry out the operations again from this screen. Operations can also be carried out again by setting the T/B [ENABLE/ DISABLE] switch to "DISABLE" once and then setting to "ENABLE".
