Mitsubishi Electronics RV-6S instruction manual J5 axis origin setting

5Maintenance and Inspection

(5) J5 axis origin setting
	<TOOL>	12345678
	BRAKE	(00000000)
	SET AXIS(11110000)
	ORIGIN	:NOT DEF		-B
			(J5)
	Designate the origin setting axis		1	DEF

Pinhole (J5 axis)

RPL

↓

Move the cursor

<TOOL>	12345678
BRAKE	(00000000)
SET AXIS(00001000)
ORIGIN	:NOT DEF	-B		・	-C		INP
		(J5)			(J6)	→ EXE
Designate the origin setting axis		1	DEF		0 ABC
<TOOL>
SET ORIGIN
OK?(1)
1:EXECUTE		-B			INP
		(J5)	→ EXE
Set the origin		1 DEF
<TOOL>	12345678
BRAKE	(00000000)

SET AXIS (00001000)

ORIGIN :COMPLETED

1)Slowly rotate the J5 axis in the direction of plus 90° with both hands. Align the pinholes of the No. 2 arm and wrist housing , feed through the origin jig (φ6) into the pinholes and fasten.

2)Press the [ ↓ ] key. The cursor will move to "SET AXIS".

3)Designate the axis for which the origin is to be set.. Set "1" for the 5 axis, and set "0" for the other axes. Then, press [INP] key. Next, a confirmation screen will appear.

4)Press the [1] and [INP] keys.

The origin posture will be set.

5)Setting of the origin is completed.

6)Refer to "5.5.4Recording the origin data" on page 65 in this manual, and record the origin data on the origin data seal.

◇◆◇ Origin setting axis designation ◇◆◇

Move the cursor to the "SET AXIS" axis No. in the origin setting with the [ ← ] or [ → ] key.

The origin is set only for the axis for which a "1" is displayed on the screen. If the origin is not to be set, press the [0] key and display a "0".

Resetting the origin 5-59