NEC 5020M-16, NX7700i operation manual HC Hardware Configuration, Function

Base Module

2.4.6.7.HC (Hardware Configuration)

m	b	u
X

* For system states and subcommand validity, read the description of subcommands.

Function:

This command is used to show the hardware configuration and enable to change it. It is also used to configure, show, or change partitions.

In a duplicated iSP environment, the hardware configuration is automatically matched between the duplicated iSPs.

Description of Subcommands

cmd	arg1	arg2	arg3	arg4	Description
help	-	-	-	-	Show a list of subcommands.
					This subcommand is always valid without
					regard to the current system state.
quit	-	-	-	-	Quit the HC command.
exit					Before the HC command quits, the check
					subcommand is automatically run.
					These subcommands are always valid
					without regard to the current system state.
disp	-	-	-	-	Show the system’s hardware configuration.
					If no argument is specified or has an error,
					the disp subcommand help opens.
					This subcommand is always valid without
					regard to the current system state.
	all	-	-	-	Argument “all” shows all the configuration
					information.
	part	-	-	-	Show the current partitioning.
					The following information is given for each
					partition:
					State summary
					Physical CELL No. and logical CELL No.
					Physical IOX No. and logical IOX No.
					Size of shared memory (ISPF only)
	main	-	-	-	Show the Main Cabinet or Main Chassis
					configuration.
					For the 8Way/ISPF model, the configurations
					of external PCI Bay and Power Bay are also
					shown.
	exp	-	-	-	Valid only for the 32Way model.
					Use this argument to show the expansion
					cabinet configuration.
	cellx	-	-	-	Show the CELL configuration.
					X denotes a physical CELL number (0-7).

2-45 855-900549