NEC 5020M-16, NX7700i operation manual Base Module

							Base Module
cmd	arg1		arg2		arg3	arg4	Description
add	-	-		-		-	Use this command to manually inform the
							iSP of an addition of components. iSP’s
							management state will change from
							“nonexist.” to “power-off.”
							If no argument is specified or an argument
							has an error, the add command help opens.
							This command is always valid without regard
							to the current system state (with the
							exception of the PBAY, to which this
							command is valid only if none of the
							partitions is active).
							This command is not valid to the CELL
							Cards, XBX Cards, PCI Bay, or their
							subcomponents if any of the partitions within
							the system is booting up, shutting down, or
							handling an error.
	pbayx	-		-		-	Add Power Bays.
							x is a Power Bay number. The allowable
							value of x is as follows:
							For 32Way:
							0, 1: Power Bay No. in the Main Cabinet
							2, 3: Power Bay No. in the Expansion
							Cabinet
							For 8Way:
							0: Power Bay No. inside the chassis
							1: Power Bay No. outside the chassis
							For ISPF:
							0: Power Bay No. inside the chassis
	dpsxy	-		-		-	Add DPS’s to Power Bays.
							The meaning of x is identical to that for
							argument pbay.
							y is a DPS No. within a Power Bay (0-5).
	ispx	-		-		-	Add backup iSPs.
							x is the physical number of an iSP (0 or 1).
							Backup iSPs can only be added to the
							32Way model.
	clkx	-		-		-	Add CLK Cards.
							x is the physical number of the CLK Card (0
							or 1).
							The CLK Card can only be added to the
							32Way model.
	xbxcx	-		-		-	Add XBX Cards.
							x is an XBX Card number (0-3).
							The SP will automatically recognize the
							number of XBX LSI chips installed on the
							XBX Card.
	cellx	-		-		-	Add CELL Cards.
							x is the physical number of the CELL Card
							(0-7).
	procxy	-		-		-	Add processors.
							x is the physical number of the CELL Card
							(0-7).
							y is the location of the processor on the
							CELL Card (0-3).

2-49 855-900549