Configuring Your Server 4-45

CONFIGURING MOTHER BOARD JUMPERS

You can use the following procedure to clear the CMOS data in the server.

IMPORTANT:

„Clearing the CMOS data resumes the factory-set configuration data.

„Do not change any other switch settings. Any change may cause the server to fail or malfunction.

„Clearing CMOS sets [SATA RAID Enabled] in the [Advanced] - [Peripheral Configuration] menu to [Disabled]. If the SATA hard disk drives are installed in your server and the onboard SATA RAID feature is used, change the parameter of the [SATA RAID Enabled] from [Disabled] to [Enabled] before exiting BIOS Setup. Leaving this parameter as the factory-set value (Disabled) may destroy the data in hard disk drive.

NOTE: To display the [SATA RAID Enabled] menu, select [Advanced] - [Peripheral Configuration] - [SATA Controller Mode Option] - [Enhanced].

Clear

Protect

Mother board