4-46 Configuring Your Server
The following describe the clearing procedure.

WARNING

Observe the following instructions to use the server safely. Failure to follow these instructions may result in death or serious personal injury. See pages 1-3 to 1-8 for details.

■Do not disassemble, repair, or alter the server.

■Do not remove the lithium battery.

■Disconnect the power plug before working with the server.

CAUTION

Observe the following instructions to use the server safely. Failure to follow these instructions may cause a fire, personal injury, or property damage. See pages 1-3 to 1-8 for details.

■Make sure to complete board installation.

■Do not pinch your finger with mechanical components.

■Avoid installation in extreme temperature conditions.

IMPORTANT: Components inside the server are easily affected by static electricity. Handle a component after making your body contact with a metallic frame section of the server to discharge the static electricity on your body. Do not make bare hands contact with terminals and components. See "Static Precautions" in this chapter for details of the static electricity.

1.See the section "Preparing for Installation and Removal" in Chapter 9 to prepare

2.Remove the left side cover (see Chapter 9).3.Change jumper switching setting from "Protect" to "Clear".

IMPORTANT:

„Use the clip over jumper pins 1 and 2 on the mother board.„Do not lose the clip.4.After three seconds later, reinstall the jumper.5.Reinstall the server and then turn on the power.